The JD-VCC pin powers the electromagnet of the relay. The second set of pins consists of GND, VCC, and JD-VCC pins. The set at the right consists of VCC and GND to power up the module, and input 1 ( IN1) and input 2 ( IN2) to control the bottom and top relays, respectively. The low-voltage side has a set of four pins and a set of three pins. If you just want to light up a lamp occasionally, it is better to use a normally-open circuit configuration. NO (Normally Open): the normally open configuration works the other way around: the relay is always open, so the circuit is broken unless you send a signal from the Arduino to close the circuit.NC (Normally Closed): the normally closed configuration is used when you want the relay to be closed by default, meaning the current is flowing unless you send a signal from the Arduino to the relay module to open the circuit and stop the current.

The high-voltage side has two connectors, each with three sockets: common (COM), normally closed (NC), and normally open (NO). The six pins on the left side of the relay module connect high voltage, and the pins on the right side connect the component that requires low voltage-the Arduino pins. The following figure shows the relay module pinout.

There are other relay modules that are powered using 3.3V, which is ideal for ESP32, ESP8266, and other microcontrollers. This module should be powered with 5V, which is appropriate to use with an Arduino. There are other models with one, four and eight channels. This relay module has two channels (those blue cubes). Introducing the Relay ModuleĪ relay is an electrically operated switch that can be turned on or off, letting the current go through or not, and can be controlled with low voltages, like the 5V provided by the Arduino pins.Ĭontrolling a relay module with the Arduino is as simple as controlling any other output as we’ll see later on. The example we’ll build shows how to control a relay module with an Arduino and a PIR motion sensor.īy the end of this tutorial, you should be able to control any electronics appliances with your Arduino using a relay module. We make a brief introduction to the relay module and build a simple project example with the Arduino. This article shows how to control mains voltage with the Arduino using a relay module.

Relay module library for proteus 8